VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
253
krx8"onf"upqqrkpi"xncp"tqwvgt/cikpi/vkog"
Fguetkrvkqp"
The"krx8"onf"upqqrkpi"xncp"tqwvgt/cikpi/vkog command is used to specify
router port aging time for a specified VLAN. If this time is set to 0, then the
global router port aging time will be used. The default time is 0. To restore the
default timer, please use pq" krx8" onf" upqqrkpi" xncp" tqwvgt/cikpi/vkog
command.
U{pvcz"
krx8"onf"upqqrkpi"xncp"vlan-id"tqwvgt/cikpi/vkog"timer
pq"krx8"onf"upqqrkpi"xncp"vlan-id"tqwvgt/cikpi/vkog
Rctcogvgt"
vlan-id —— The specified IEEE 802.1Q VLAN ID, ranging from 1 to 4094.
timer —— Aging time of the router port in seconds, ranging from 0 to 1000.
Eqoocpf"Oqfg"
Global Configuration Mode
Gzcorng"
Specify the router port aging time as 100 seconds in VLAN 2:
VN/UN764:G*eqphki+%"krx8"onf"upqqrkpi"xncp 2"tqwvgt/cikpi/vkog 100"
krx8"onf"upqqrkpi"xncp"ogodgt/cikpi/vkog"
Fguetkrvkqp"
The"krx8"onf"upqqrkpi"xncp"ogodgt/cikpi/vkog command is used to specify
member port aging time for a specified VLAN. If this time is set to 0, then the
global member port aging time will be used. The default time is 0. To restore the
default timer, please use pq" krx8" onf" upqqrkpi" xncp" ogodgt/cikpi/vkog
command.
U{pvcz"
krx8"onf"upqqrkpi"xncp"vlan-id"ogodgt/cikpi/vkog"timer
pq"krx8"onf"upqqrkpi"xncp"vlan-id"ogodgt/cikpi/vkog
Rctcogvgt"
vlan-id ——The specified IEEE 802.1Q VLAN ID, ranging from 1 to 4094.
timer —— Aging time of the member port in seconds, ranging from 200 to 1000
and 0.
Eqoocpf"Oqfg"
Global Configuration Mode
To Next Page
Loading...
