VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
146
Ejcrvgt"45" KRx8"Cfftguu"Eqphkiwtcvkqp"Eqoocpfu"
The IPv6 address configuration commands are provided in the Interface VLAN Mode. Type"
gpcdng" →eqphkiwtg→kpvgthceg" xncp {vlan-id} to enter the Interface Configuration Mode of the
management VLAN. By default the management VLAN is VLAN1. You can use the command kr"
ocpcigogpv/xncp" {vlan-id} in the Global Configuration Mode to configure the management
VLAN.
krx8"gpcdng"
Fguetkrvkqp"
This command is used to enable the IPv6 function globally. The IPv6 function should be
enabled before the IPv6 address configuration management. By default it is enabled. If
the IPv6 function is disabled, the corresponding IPv6 netstack and IPv6-based modules
will be invalid, for example SSHv6, SSLv6, TFTPv6 etc. To disable the IPv6 function,
please use"pq"krx8"gpcdng command.
U{pvcz"
krx8"gpcdng"
pq"krx8"gpcdng" "
Eqoocpf"Oqfg"
Interface Configuration Mode（interface vlan）
Gzcorng"
Enable the IPv6 function when the management VLAN of the switch is VLAN1：
VN/UN764:G*eqphki+%"kpvgthceg"xncp"1"
VN/UN764:G*eqphki/kh+%"krx8"gpcdng"
krx8"cfftguu"cwvqeqphki"
Fguetkrvkqp"
This command is used to enable the automatic configuration of the ipv6 link-local
address. The switch has only one ipv6 link-local address, which can be configured
automatically or manually. The general ipv6 link-local address has the prefix as
fe80::/10. IPv6 routers cannot forward packets that have link-local source or
destination addresses to other links. The autuconfigured ipv6 link-local address is in
EUI-64 format. To verify the uniqueness of the link-local address, the manually
To Next Page
Loading...
