TP-Link TL-SL5428E - dot1 x port-control; dot1 x port-method

VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
100
fqv3z"rqtv/eqpvtqn"
Fguetkrvkqp"
The fqv3z" rqtv/eqpvtqn command is used to configure the Control Mode of
IEEE 802.1X for the specified port. By default, the control mode is “auto”. To
restore to the default configuration, please use" pq" fqv3z" rqtv/eqpvtqn
command.
U{pvcz"
fqv3z"rqtv/eqpvtqn"{auto | authorized-force | unauthorized-force}
pq"fqv3z"rqtv/eqpvtqn"
Rctcogvgt"
auto | authorized-force | unauthorized-force —— The Control Mode for the port.
auto:
" In this mode, the port will normally work only after passing the 802.1X
Authentication.
authorized-force: In this mode, the port can work normally without passing the
802.1X Authentication.
unauthorized-force: In this mode, the port is forbidden working for its fixed
unauthorized status.
Eqoocpf"Oqfg"
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)
Gzcorng"
Configure the Control Mode for Gigabit Ethernet"port 25 as “authorized-force”:
VN/UN764:G*eqphki+%kpvgthceg"ikicdkvGvjgtpgv"1/0/25"
VN/UN764:G*eqphki/kh+%fqv3z"rqtv/eqpvtqn"authorized-force"
fqv3z"rqtv/ogvjqf"
Fguetkrvkqp"
The fqv3z"rqtv/ogvjqf command is used to configure the control type of IEEE
802.1X for the specified port. By default, the control type is “mac-based”. To
restore to the default configuration, please use" pq" fqv3z" rqtv/ogvjqf
command.