TP-Link TL-SL5428E - ipv6 mld snooping filter-mode; ipv6 mld snooping filter-id

VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
259
Interface Configuration Mode
Gzcorng"
Enable filter function on interface gigabitEthernet 1/0/2:
VN/UN764:G*eqphki+%"kpvgthceg"ikicdkvGvjgtpgv"1/0/2"
VN/UN764:G*eqphki/kh+%"krx8"onf"upqqrkpi"hknvgt"
krx8"onf"upqqrkpi"hknvgt/oqfg"
Fguetkrvkqp"
The" krx8" onf" upqqrkpi" hknvgt/oqfg command is used to configure the filter
mode of the interface. The default mode is accept. To restore the default mode,
please use pq"krx8"onf"upqqrkpi"hknvgt/oqfg command.
U{pvcz"
krx8"onf"upqqrkpi"hknvgt/oqfg"}accept"~"refuseÄ"
pq"krx8"onf"upqqrkpi"hknvgt/oqfg"
Rctcogvgt"
accept —— Accept the multicast groups within the filter entry.
refuse —— Refuse the multicast groups within the filter entry.
Eqoocpf"Oqfg"
Interface Configuration Mode
Gzcorng"
Configure the filter mode as refuse on interface gigabitEthernet 1/0/2:
VN/UN764:G*eqphki+%"kpvgthceg"ikicdkvGvjgtpgv 1/0/2
VN/UN764:G*eqphki/kh+%"krx8"onf"upqqrkpi"hknvgt/oqfg refuse"
krx8"onf"upqqrkpi"hknvgt/kf"
Fguetkrvkqp"
The"krx8"onf"upqqrkpi"hknvgt/kf command is used to specify the filter id on the
interface. To disable this configuration, please use pq" krx8" onf" upqqrkpi"
hknvgt/kf command.
U{pvcz"
krx8"onf"upqqrkpi"hknvgt/kf"filter-list"
pq"krx8"onf"upqqrkpi"hknvgt/kf"