VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
218
Eqoocpf"Oqfg"
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)
Gzcorng"
For error frame event, configure the error threshold as 6 and the event detection
interval as 9 seconds on Fast Ethernet port 3:
VN/UN764:G*eqphki+%"kpvgthceg"hcuvGvjgtpgv"1/0/3"
VN/UN764:G*eqphki/kh+%" gvjgtpgv/qco" nkpm/oqpkvqt" htcog" vjtgujqnf" 6"
ykpfqy"90"
gvjgtpgv/qco"nkpm/oqpkvqt"htcog/rgtkqf
Fguetkrvkqp"
The gvjgtpgv/qco nkpm/oqpkvqt"htcog/rgtkqf command is used to configure
the parameters about one of the link events, error frame period event. To return
to the default configurations, please use pq" gvjgtpgv/qco" nkpm/oqpkvqt"
htcog/rgtkqf command.
U{pvcz"
gvjgtpgv/qco" nkpm/oqpkvqt" htcog/rgtkqf" { [vjtgujqnf" threshold" ] [ ykpfqy"
window"] [pqvkh{ {"disable | enable } ] }
pq"gvjgtpgv/qco"nkpm/oqpkvqt"htcog/rgtkqf"{ threshold | window | notify"}
Rctcogvgt"
threshold —— Configure the error threshold for generating error frame period
event. The range is from 1 to 4294967295 and the default value is 1.
window —— Configure the error frame period event detection interval. The
range is from 148810 to 89286000. The default value is 148810 for Fast
Ethernet port and 1488100 for Gigabit Ethernet port.
notify —— Enable/Disable the event notification. By default, it is enabled.
threshold | window | notify —— The parameter that you want to return to the
default configuration.
To Next Page
Loading...
