TP-Link TL-SL5428E - snmp-server traps link-status; snmp-server traps

VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
275
Gzcorng"
Enable the dhcp-filter trap for the switch:
VN/UN764:G*eqphki+%"upor/ugtxgt"vtcru"ugewtkv{ dhcp-filter"
upor/ugtxgt"vtcru"nkpm/uvcvwu"
Fguetkrvkqp"
The upor/ugtxgt" vtcru" nkpm/uvcvwu" command is used to enable SNMP link
status trap for the specified port. To disable the sending of SNMP link status trap,
please use pq"upor/ugtxgt"vtcru"nkpm/uvcvwu"command.
U{pvcz"
upor/ugtxgt"vtcru"nkpm/uvcvwu
pq"upor/ugtxgt"vtcru"nkpm/uvcvwu"
Eqoocpf"Oqfg"
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Gzcorng"
Enable SNMP link status trap for port 3:
VN/UN764:G*eqphki+%"kpvgthceg"ikicdkvGvjgtpgv"1/0/3"
VN/"UI5646R*eqphki/kh+%"upor/ugtxgt"vtcru"nkpm/uvcvwu"
upor/ugtxgt"vtcru"
Fguetkrvkqp"
The upor/ugtxgt"vtcru command is used to enable SNMP extended traps. To
disable the sending of SNMP extended traps, please use pq" upor/ugtxgt"
vtcru"command.
U{pvcz"
upor/ugtxgt" vtcru" { bandwidth-control | cpu | flash | ipaddr-change | lldp |
loopback-detection | storm-control | spanning-tree | memory }
pq"upor/ugtxgt"vtcru"{ bandwidth-control | cpu | flash | ipaddr-change | lldp |
loopback-detection | storm-control | spanning-tree | memory }"