VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
135
kr"cfftguu"
Fguetkrvkqp"
The"kr"cfftguu"command is used to configure the system IP address, Subnet
Mask and Default Gateway. To restore to the factory defaults, please use pq"kr"
cfftguu" command. This command should be configured in the Interface
Configuration Mode of the management VLAN.
U{pvcz"
kr"cfftguu"{ip-addr} {ip-mask} [gateway]
pq"kr"cfftguu"
Rctcogvgt"
ip-addr —— The system IP of the switch. The default system IP is 192.168.0.1.
ip-mask —— The Subnet Mask of the switch. The default Subnet Mask is
255.255.255.0.
gateway —— The Default Gateway of the switch. By default, it is empty.
Eqoocpf"Oqfg"
Interface Configuration Mode (interface vlan)
Gzcorng"
Configure the system IP as 192.168.0.69 and the Subnet Mask as
255.255.255.0 when the management VLAN of the switch is VLAN1:
VN/UN764:G*eqphki+%"kpvgthceg"xncp"1"
VN/UN764:G*eqphki/kh+%"kr"cfftguu"192.168.0.69 255.255.255.0"
kr"cfftguu/cnnqe"fjer"
Fguetkrvkqp"
The" kr" cfftguu/cnnqe" fjer" command is used to enable the DHCP Client
function. When this function is enabled, the switch will obtain IP from DHCP
Client server. This command should be configured in the Interface Configuration
Mode of the management VLAN.
U{pvcz"
kr"cfftguu/cnnqe"fjer"
Eqoocpf"Oqfg"
Interface Configuration Mode (interface vlan)"
To Next Page
Loading...
