TP-Link TL-SL5428E - pppoe circuit-id type

VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
104
U{pvcz"
rrrqg"ektewkv/kf"
pq"rrrqg"ektewkv/kf"
Eqoocpf"Oqfg"
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)
Gzcorng"
Enable the PPPoE Circuit-ID Insertion function for the Fast Ethernet port 1/0/1:
VN/UN764:G"*eqphki+%"kpvgthceg"hcuvGvjgtpgv"1/0/1"
VN/UN764:G"*eqphki/kh+%"rrrqg"ektewkv/kf"
rrrqg"ektewkv/kf"v{rg"
Fguetkrvkqp"
The rrrqg"ektewkv/kf"v{rg command is used to configure the type of PPPoE
Circuit-ID for a specified port. By default, the PPPoE Circuit-ID type is “ip”.
U{pvcz"
rrrqg"ektewkv/kf"v{rg { mac | ip | udf [UDF Value] }
Rctcogvgt"
mac | ip | udf —— The type of PPPoE Circuit-ID for the port.
mac: The MAC address of the switch will be used to encode the Circuit-ID
option.
ip: The IP address of the switch will be used to encode the Circuit-ID option.
This is the default value.
udf: A user specified string with the maximum length of 32 characters will be
used to encode the Circuit-ID option.
UDF Value —— The value of UDF. The maximum length is 32 characters.
Eqoocpf"Oqfg"
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)