VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
72
Eqoocpf"Oqfg"
Global Configuration Mode
Gzcorng"
Bind an ACL entry with the IP 192.168.0.1, MAC 00:00:00:00:00:01, VLAN ID 2
and the Port number 5 manually. And then enable the entry for the ARP
detection and IP filter function:
VN/UN764:G*eqphki+%kr"uqwteg"dkpfkpi host1 192.168.0.1 00:00:00:00:00:01
xncp 2 kpvgthceg"hcuvGvjgtpgv"1/0/5 both
Delete the IP-MAC –VID-PORT entry with the index 5:
VN/UN764:G*eqphki+%pq"kr"uqwteg"dkpfkpi"kpfgz"5
kr"uqwteg"dkpfkpi"kpfgz"
Fguetkrvkqp"
The"k r"uqwteg dkpfkpi"kpfgz command is used to modify the existing entry of
ip source binding.
U{pvcz"
kr" uqwteg" dkpfkpi" kpfgz" idx {jquvpcog hostname | oce mac-addr | xncp"
vlan-id| kpvgthceg" { hcuvGvjgtpgv port | ikicdkvGvjgtpgv port} | none |
arp-detection | ip-verify-source | both }
Rctcogvgt"
idx ——The entry number needed to be modified. You can use the show ip
source binding command to get the idx. Pay attention that the entry number is
the actual number in the binding table which is not displayed in an arranged
order.
hostname ——The modified Host Name, which contains 20 characters at most.
mac-addr —— The modified MAC address of the Host.
vlan-id ——The modified VLAN ID, ranging from 1 to 4094.
port —— The modified number of port connected to the Host.
none | arp-detection | ip-verify-source | both ——The modified protect type for
the entry. “arp-detection” indicates ARP detection; “ip-verify-source” indicates IP
source filter; “none” indicates applying none; “both” indicates applying both.
To Next Page
Loading...
