VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
305
vcececu/ugtxgt"jquv"
Fguetkrvkqp"
The vceceu/ugtxgt"jquv"command is used to configure a new TACACS+ server.
To delete the specified TACACS+ server, please use pq" vceceu/ugtxgt jquv
command.
U{pvcz"
vceceu/ugtxgt"jquv ip-address ["rqtv port-id ] [ vkogqwv time ] [ mg{ { [ 0 ] string
| 7 encryped-string } ]
pq"vceceu/ugtxgt"jquv"ip-address
Rctcogvgt"
ip-address —— Specify the IP address of the TACACS+ server.
port-id —— Specify the server’s port number for AAA. By default it is 49.
time —— Specify the time in seconds the switch waits for the server’s response
before it times out. The time ranges from 1 to 9 seconds. The default is 5
seconds.
[ 0 ] string | 7 encrypted-string —— 0 and 7 are the encryption type. 0 indicates
that an unencrypted key will follow. 7 indicates that a symmetric encrypted key
with a fixed length will follow. By default, the encryption type is 0. “string” is the
shared key for the switch and the authentication servers to exchange messages
which contains 31 characters at most. The question marks and spaces are not
allowed. “encrypted-string” is a symmetric encrypted key with a fixed length,
which you can copy from another switch’s configuration file. The key or
encrypted-key you configured here will be displayed in the encrypted form.
Always configure the key as the last item of this command.
Eqoocpf"Oqfg"
Global Configuration Mode
Wugt"Iwkfgnkpgu"
The TACACS+ servers you configured are added in the server group “tacacs” by
default.
To Next Page
Loading...
