VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
128
Ejcrvgt"44" U{uvgo"Eqphkiwtcvkqp"Eqoocpfu"
System Configuration Commands can be used to configure the system information and system IP
of the switch, and to reboot and reset the switch, upgrade the switch system and commands used
for device diagnose, including loopback test and cable test.
u{uvgo/vkog"ocpwcn"
Fguetkrvkqp"
The u{uvgo/vkog" ocpwcn" command is used to configure the system time
manually.
U{pvcz"
u{uvgo/vkog"ocpwcn"time"
Rctcogvgt"
time
——
Set the date and time manually, in the format of MM/DD/YYYY-
HH:MM: SS.
Eqoocpf"Oqfg"
Global Configuration Mode
Gzcorng"
Configure the system time as 02/14/2012-12:30:00:"
VN/UN764:G*eqphki+%u{uvgo/vkog"ocpwcn"02/14/2012-12:30:00
u{uvgo/vkog"pvr"
Fguetkrvkqp"
The"u{uvgo/vkog"pvr"command is used to configure the time zone and the IP
address for the NTP Server. The switch will get UTC automatically if it has
connected to an NTP Server.
U{pvcz"
u{uvgo/vkog" pvr" { timezone } { ntp-server } { backup-ntp-server }
{ fetching-rate }"
Rctcogvgt"
timezone —— Your local time-zone, and it ranges from UTC-12:00 to
UTC+13:00.
The detailed information that each time-zone means are displayed as follow:
To Next Page
Loading...
