TP-Link TL-SL5428E - enable authentication(telnet); line ssh

VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
317
VN/UN764:G*eqphki/nkpg+%"nqikp"cwvjgpvkecvkqp"list1
gpcdng"cwvjgpvkecvkqp*vgnpgv+"
Fguetkrvkqp"
The" gpcdng" cwvjgpvkecvkqp command is used to apply the privilege
authentication method list to the telnet terminal line. To restore to the default
authentication method list, please use the pq"gpcdng"cwvjgpvkecvkqp"command.
U{pvcz"
gpcdng"cwvjgpvkecvkqp"{ method-list }
pq"gpcdng"cwvjgpvkecvkqp
Rctcogvgt"
method-list —— Specify the enable method list on the telnet terminal line. It is
“default” by default, which contains the method “none”.
Eqoocpf"Oqfg"
Line Configuration Mode
Gzcorng"
Configure the enable authentication method list on the telnet terminal line as
“list2”:
VN/UN764:G*eqphki+%nkpg"vgnpgv
VN/UN764:G*eqphki/nkpg+%"gpcdng"cwvjgpvkecvkqp"list2
nkpg"uuj"
Fguetkrvkqp"
The"nkpg uuj command is used to enter the Line Configuration Mode configure
the ssh terminal line to which you want to apply the authentication list.
U{pvcz"
nkpg"uuj
Eqoocpf"Oqfg"
Global Configuration Mode