VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
296
VN/UN764:G*eqphki+%enwuvgt"pfr" "
VN/UN764:G*eqphki+%enwuvgt"pfr"vkogt"jgnnq"50 cikpi"120"
enwuvgt"pvfr"
Fguetkrvkqp"
The enwuvgt"pvfr command is used to configure NTDP globally. To return to the
default configuration, please use pq" enwuvgt"pvfr command. NTDP (Neighbor
Topology Discovery Protocol) is used to collect the NDP information and
neighboring connection information of each device in a specific network range. It
provides the commander switch with the information of devices which can join
the cluster and collects topology information of devices within the specified hops.
U{pvcz"
enwuvgt"pvfr"
enwuvgt"pvfr"vkogt { [kpvgtxcn/vkog"time] [jqr/fgnc{ value]"[rqtv/fgnc{ value] }"
enwuvgt"pvfr"jqr hop-value"
pq"enwuvgt"pvfr" "
pq" enwuvgt" pvfr" vkogt" { [kpvgtxcn/vkog" time] [jqr/fgnc{ value]" [rqtv/fgnc{
value] }"
pq"enwuvgt"pvfr"jqr hop-value"
Rctcogvgt"
time —— NTDP Interval Time, which is the interval to collect topology
information. NTDP Interval Time ranges from 1 to 60 in minutes. By default, it is 1.
jqr/fgnc{ value —— NTDP Hop Delay, which is the time between the switch
receiving NTDP request packets and the switch forwarding NTDP request
packets for the first time. NTDP Hop Delay ranges from 1 to 1000 in
milliseconds. By default, it is 200.
rqtv/fgnc{ value —— NTDP Port Delay, which is the time between the port
forwarding NTDP request packets and its adjacent port forwarding NTDP
request packets over. NTDP Port Delay ranges from 1 to 100 in milliseconds. By
default, it is 20.
hop-value —— NTDP Hops, which is the hop count the switch topology
collects. NTDP Hops ranges from 1 to 16. By default, it is 3.
Eqoocpf"Oqfg"
Global Configuration Mode
To Next Page
Loading...
