VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
25
kpvgthceg"xncp
Fguetkrvkqp"
The"kpvgthceg"xncp command is used to create VLAN Interface hereafter to
access to Interface VLAN Mode.
U{pvcz"
kpvgthceg"xncp"vlan-id
pq"kpvgthceg"xncp"vlan-id
Rctcogvgt"
vlan-id —— Specify IEEE 802.1Q VLAN ID, ranging from 1 to 4094.
Eqoocpf"Oqfg"
Global Configuration Mode
Gzcorng"
Create VLAN Interface 2:
VN/UN764:G*eqphki+%kpvgthceg"xncp"2"
pcog
Fguetkrvkqp"
The pcog command is used to assign a description string to a VLAN. To clear
the description, please use pq"pcog command.
U{pvcz"
pcog"descript
pq"pcog
Rctcogvgt"
descript —— String to describe the VLAN, which contains 16 characters at
most.
Eqoocpf"Oqfg"
VLAN Configuration Mode（VLAN）
To Next Page
Loading...
