Azbil C7G User Manual

14-24
Chapter 14. Appendix
Description User's Manual Reference User's Manual Change
Added Bias specification method in
Linear approximation table
4 - 16 Linear Approximation (p.4-90)
Linearization by specifying bias (p.4-91)
Added the content at left
6 - 2 Parameter Setting Display Data
Linearization table bank (p.6-35)
Added “Operation types” items
Added user-defined values
1 - 5 Button Operation
Parameter bank (p.1-12)
Added user-defined values (USER
DEFINED VALUE)
6 - 2 Parameter Setting Display Data
User-defined bit bank (p.6-28)
Added the content at left
14 - 2 Standard Bit Codes and Standard
Numerical Codes
14 - 2 Standard Bit Codes and Standard
Numerical Codes (p.14-6)
The standard numerical codes
include numbers corresponding
to user-defined values 1 to 16.
Added standard numerical codes
4 - 9 Events
Operation (p.4-56),
Operation type and Loop definition (p.4-61)
Added standard numerical code
high limit, standard numerical
code low limit, standard
numerical code high and low
limits, standard numerical code
change rate high limit, and
standard numerical code change
rate low limit to “Operation
types”
Added standard numbers to
“Loop definition”
6 - 2 Parameter Setting Display Data
EVENT CONFIG bank (p.6-17)
Same as above
4 - 11 TP (Time Proportioning) Output
TP output type (p.4-69)
Added standard numerical codes
to “TP output types”
6 - 2 Parameter Setting Display Data
TP (time proportioning) bank (p.6-24)
Same as above
4 - 12 Analog Output (AO)
Output type (p.4-75)
Added standard numerical codes
to “Output types”
6 - 2 Parameter Setting Display Data
ANALOG OUTPUT bank (p.6-16),
Same as above
14 - 2 Standard Bit Codes and Standard
Numerical Codes
Added the content at left

Azbil C7G Specifications

General

Brand	Azbil
Model	C7G
Category	Controller
Language	English