14-26
Chapter 14. Appendix
Specification changes
Description User's Manual Reference User's Manual Change
Changed the time proportioning current
from undefined to 0.0 A when CT operation
in Time proportioning current is Heater
burnout detection for the OUT terminal and TP
operation type is Priority on controllability
4 - 14 CT (Current Transformer) Input
(p.4-81)
Current measurement and error
detection CT operation
Handling Precautions (p.4-84)
Added the description “Time
proportioning current = 0.0 A.”
Increased the setting range of “Decimal point
position” for user-defined addresses and
enabled RAM area definition
Chapter 9. User-defined Addresses
(p.9-1)
Changed the setting range of
the decimal point position from
“0 to 4” to “0 to 4, 10 to 14”
9 - 2 Address Definition Method
User-defined addresses (p.9-1)
RAM area (p.9-5)
Added a description of defining
the RAM area using the decimal
point position setting
Added a display for the model No. and S/N
(serial number) to the firmware version display
screen
5 - 2 Parameter screen
Firmware Versions (p.5-52)
Added a description of the
display for the model No. and
S/N (serial number)
Changed so that the ON/OFF status of standard
bit codes 1171 to 1174 (DI/DO4 terminal status
to DI/DO7 terminal status) is reflected even
when using digital output with TP
14 - 2 Standard Bit Codes and
Standard Numerical Codes
Standard bit codes (p.14-6)
Not changed
Support start date: August 2018
Block Firmware version (X is 0 to 9)
MAIN block 6.0.X
HMI block (display unit, additional display unit) 6.0.X
DI/DO block 3.0.X
RS-485 block 3.0.X
AO-C block (slots A1 to A2, B1 to B2) 3.0.X
V-P block (slots A1 to A2, B1 to B2) 1.0.X
AI block (slots A3 to A4, B3 to B4) 3.1.X
CLOCK block (slot B1) 1.0.X
MOTOR block (slot B2) 1.0.X
DI block 1.0.X
DO block 1.0.X
To Next Page
Loading...
Need help?
General
