Quilting
Various Stitches
115
3
Attaching the Stitch Regulator
and Presser Foot
1
Press (Needle position button) to
raise the needle.
2 Touch to lock all keys and buttons.
* If the message [OK to automatically lower the
presser foot?] appears on the LCD screen, touch
[OK] to continue.
3 Raise the presser foot lever.
4 Remove the presser foot and presser foot
holder. (page 48)
5 Prepare the presser foot to be used with
the stitch regulator.
6 If the presser foot already attached to the
stitch regulator will not be used, slowly
push the presser foot release button
toward you as far as it will go, and then
remove the presser foot after it has been
ejected.
7 Correctly orient the presser foot, insert it
horizontally into the presser foot slot,
and then push it in as far as it will go.
a Presser foot slot
b Presser foot
8 Pull the presser foot slightly toward you
to check if it is firmly secured. If the
presser foot comes out, reinsert it as far
as it will go.
9 Align the notch in the stitch regulator
with the screw on the presser bar, and
then firmly tighten the screw.
CAUTION
• Before installing or removing the stitch regulator or
replacing the presser foot, be sure to touch to lock
all keys and buttons. Unintentional operations such as
pressing a button may cause the machine to start
operating, resulting in injuries.
• We strongly advise to not use the stitch regulator open
toe quilting foot when in [Basting mode], as the
possibility of needle breakage is increased.
IMPORTANT
• Do not install the stitch regulator onto the machine if the
stitch regulator is wet or has been damaged from being
dropped. The laser sensor may have been damaged.
• Before using the stitch regulator, check the
window at the bottom. Remove any
accumulated dust or lint with a cotton swab or
other soft object without damaging the built-in
lens. Do not use hard objects such as needles
or tweezers.
a Stitch regulator window
CAUTION
• Make sure that the presser foot is firmly secured.
Otherwise, the presser foot may come off or the needle
may break, causing injuries.
To Next Page
