Cisco Nexus 7000 Series

E Commands
event storm-control
166
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
event storm-control
To specify an event criteria for an Embedded Event Manager (EEM) applet that is run on the basis of a
storm control event, use the event storm-control command. To remove the storm control event criteria,
use the no form of this command.
event storm-control
no event storm-control
Syntax Description This command has no arguments or keywords.
Defaults None
Command Modes Embedded event manager
Supported User Roles network-admin
vdc-admin
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to specify that an EEM applet runs when a storm control event occurs:
switch# configure terminal
switch(config)# event manager applet storm-applet
switch(config-applet)# event storm-control
switch(config-applet)#
Release Modification
4.0(1) This command was introduced.