Cisco Nexus 7000 Series

L Commands
lldp reinit
232
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
lldp reinit
To configure the delay time for the Link Layer Discovery Protocol (LLDP) to initialize on any interface,
use the lldp reinit command. To remove the LLDP initialization configuration, use the no form of this
command.
lldp reinit seconds
Syntax Description
Defaults 2 seconds
Command Modes Global configuration mode (config)
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines Make sure that you are in the correct virtual device context (VDC). To switch VDCs, use the switchto
vdc command.
This command does not require a license.
Examples This example shows how to configure the delay time for LLDP initialization:
switch(config)# lldp reinit 6
switch(config)#
This example shows how to remove the LLDP initialization configuration:
switch(config)# no lldp reinit 6
switch(config)#
Related Commands
seconds Initialize time in seconds. The range is from 1 to 10.
Release Modification
5.0(1) This command was introduced.
Command Description
lldp holdtime Specifies the amount of time in seconds that a receiving device should hold
the information sent by your device before discarding it.