Cisco Nexus 7000 Series

L Commands
logging monitor
255
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
logging monitor
To log messages to the monitor (terminal line), use the logging monitor command to enable the device.
To disable monitor log messages, use the no form of this command.
logging monitor [severity-level]
no logging monitor
Syntax Description
Defaults 5
Command Modes Global configuration mode
Supported User Roles network-admin
vdc-admin
Command History
Usage Guidelines This configuration applies to Telnet and SSH sessions.
This command does not require a license.
severity-level (Optional) Number of the desired severity level at which messages should be
logged. Messages at or numerically lower than the specified level are logged.
Severity levels are as follows:
• 0—emergency: System unusable
• 1—alert: Immediate action needed
• 2—critical: Critical condition—default level
• 3—error: Error condition
• 4—warning: Warning condition
• 5—notification: Normal but significant condition
• 6—informational: Informational message only
• 7—debugging: Appears during debugging only
Release Modification
4.0(1) This command was introduced.