Cisco Nexus 7000 Series

C Commands
cdp timer
40
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
cdp timer
To configure the Cisco Discovery Protocol (CDP) refresh time interval, use the cdp timer command. To
remove the CDP refresh time interval configuration, use the no form of this command.
cdp timer seconds
no cdp timer seconds
Syntax Description
Defaults None
Command Modes Global configuration mode (config)
Supported User Roles network-admin
vdc-admin
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to configure the CDP refresh time interval:
switch(config)# cdp timer 45
switch(config)#
This example shows how to remove the CDP refresh time interval:
switch(config)# no cdp timer 45
switch(config)#
Related Commands
seconds Time interval in seconds. The range is from 5 to 254.
Release Modification
4.0(1) This command was introduced.
Command Description
cdp holdtime Configures the time that CDP holds onto neighbor information before
refreshing it.