Cisco Nexus 7000 Series

L Commands
lldp holdtime
228
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
lldp holdtime
To configure the amount of time that a receiving device should hold the information sent by your device
before discarding it, use the lldp holdtime command. To remove the hold time configuration, use the no
form of this command.
lldp holdtime seconds
Syntax Description
Defaults 120 seconds
Command Modes Global configuration mode (config)
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines Make sure that you are in the correct virtual device context (VDC). To switch VDCs, use the switchto
vdc command.
This command does not require a license.
Examples This example shows how to configure the Link Layer Discovery Protocol (LLDP) hold time:
switch(config)# lldp holdtime 180
switch(config)#
This example shows how to remove the LLDP hold time configuration:
switch(config)# no lldp holdtime 180
switch(config)#
Related Commands
seconds Hold time in seconds. The range is from 10 to 255 seconds.
Release Modification
5.0(1) This command was introduced.
Command Description
lldp reinit Specifies the delay time in seconds for LLDP to initialize on any interface.