Cisco Nexus 7000 Series

Show Commands
show ntp status
578
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
show ntp status
To display the Network Time Protocol (NTP) distribution status, use the show ntp status command.
show ntp status [ > | >> | | ]
Syntax Description
Defaults Disabled
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command shows whether Cisco Fabric Services (CFS) is enabled or disabled for the NTP
application and whether a fabric lock is in place because a configuration is in progress.
This command does not require a license.
Examples This example shows how to display the CFS distribution status for NTP. In this example, CFS
distribution is enabled and the fabric is locked. When a configuration is in progress on a CFS-enabled
device, the fabric is locked until the change is committed and the configuration is distributed throughout
the fabric. The lock prevents multiple configurations occurring at the same time.
switch(config)# show ntp status
Distribution : Enabled
Last operational state: Fabric Locked
> (Optional) Redirects the command output to a file.
>> (Optional) Redirects the command output to a file in append mode.
| (Optional) Pipes the command output to a filter.
Release Modification
4.1(2) This command was introduced.