Cisco Nexus 7000 Series

L Commands
logging source-interface
259
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
logging source-interface
To enable a source interface for the remote syslog server, use the logging source-interface command.
To disable the source interface, use the no form of this command.
logging source-interface loopback virtual_interface
no logging source-interface loopback virtual_interface
Syntax Description
Defaults None
Command Modes Global configuration mode
Supported User Roles network-admin
vdc-admin
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to enable a source interface for the syslog server:
switch# configure terminal
switch(config)# logging source-interface loopback 5
switch(config)#
loopback
virtual_interface
Enables the loopback interface.The range is from 0 to 1023.
Release Modification
4.0(1) This command was introduced.