Cisco Nexus 7000 Series

A Commands
action counter
5
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
action counter
To set or modify a named counter when an Embedded Event Manager (EEM) applet is triggered, use the
action counter command. To restore the default value to the counter, use the no form of this command.
action label counter name name value value op {dec | inc | nop | set}
no action label counter name name
Syntax Description
Defaults None
Command Modes Embedded event manager
Supported User Roles network-admin
vdc-admin
Command History
Usage Guidelines This command does not require a license.
label Unique identifier that can be any string value. Actions are sorted and run in an
ascending alphanumeric sequence using the label as the sort key. If the string
contains embedded blanks, enclose it in double quotation marks.
name name Specifies the name of the counter. This identifier can be any string value.
value value Specifies the value of the counter. This identifier must be an integer value in the
range from –2147483648 to 2147483647 inclusive, or a $-prefixed name (for
parameter substitution).
op Specifies the operation to perform upon the counter.
dec Decrements the counter by the specified value.
inc Increments the counter by the specified value.
nop Does nothing, using this keyword just displays the specified value.
set Sets the counter to the specified value.
Release Modification
4.0(1) This command was introduced.