Cisco Nexus 7000 Series

Show Commands
show interface ethernet
514
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
show interface ethernet
To display the Energy Efficient Ethernet (EEE) status on an interface, Use the show interface command.
show interface ethernet slot/chassis
Syntax Description
Defaults None.
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to display the EEE status on an interface:
switch# show interface ethernet2/6
Ethernet2/6 is down (Link not connected)
admin state is up, Dedicated Interface
Hardware: 10000 Ethernet, address: 0022.5579.de41 (bia 001b.54c1.af5d)
MTU 1500 bytes, BW 10000000 Kbit, DLY 10 usec
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, medium is broadcast
auto-duplex, auto-speed, media type is 10G
Beacon is turned off
Auto-Negotiation is turned off
Input flow-control is off, output flow-control is off
Auto-mdix is turned off
Rate mode is shared
Switchport monitor is off
EtherType is 0x8100
EEE (efficient-ethernet) : n/a
Last link flapped never
Last clearing of "show interface" counters never
0 interface resets
30 seconds input rate 0 bits/sec, 0 packets/sec
30 seconds output rate 0 bits/sec, 0 packets/sec
Load-Interval #2: 5 minute (300 seconds)
slot/chassis Slot or chassis number. The range is from 1 to 253.
Release Modification
6.1(2) This command was introduced.