Show Commands
show interface ethernet capabilities
513
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
Examples This example shows how to display if an interface is EEE capable:
switch(config-if)# show interface ethernet 16/1 capabilities
Ethernet16/1
Model: N7K-F248XT-25
Type (Non SFP): 10g
Speed: 1000,10000
Duplex: full
Trunk encap. type: 802.1Q
FabricPath capable: yes
Channel: yes
Broadcast suppression: percentage(0-100)
Flowcontrol: rx-(off/on/desired),tx-(off/on/desired)
Rate mode: dedicated
Port mode: Routed,Switched
QOS scheduling: rx-(8q4t),tx-(3p5q1t)
CoS rewrite: yes
ToS rewrite: yes
SPAN: yes
UDLD: yes
MDIX: yes
TDR capable: yes
Link Debounce: yes
Link Debounce Time: yes
FEX Fabric: yes
dot1Q-tunnel mode: yes
Pvlan Trunk capable: yes
Port Group Members: 1-4
EEE (efficient-eth): yes
PFC capable: yes
switch(config-if)#