Cisco Nexus 7000 Series

R Commands
rmon event
356
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
rmon event
To configure an RMON event, use the rmon event command. To delete an RMON event, use the no form
of this command.
rmon event event-number [description text] [log] [trap community-string] [owner owner-name]
no rmon event event-number
Syntax Description
Defaults None
Command Modes Global configuration mode
Supported User Roles network-admin
vdc-admin
Command History
Usage Guidelines You can trigger an events created by this command with an alarm that you configured by using the rmon
alarm or rmon hcalarm commands.
Events can be used by both rmon alarm (32-bit) and hcalarm (64-bit) commands.
Note You may chose to load the default RMON events template configuration or you can delete these entries
and create new RMON events. Until you create RMON alarm configurations, however, no alarms will
be triggered by these configurations.
This command does not require a license.
event-number RMON event number. The range is from 1 to 65535.
description text (Optional) Specifies a description of the event. The maximum length is 80 characters.
log (Optional) Generates an RMON log entry in the onboard RMON log when the
event is triggered by an alarm.
trap
community-string
(Optional) Generates SNMP traps with the specified name when the event is
triggered by an alarm. The maximum length is 32 characters.
owner
owner-name
(Optional) Specifies an owner for the alarm. The maximum length is 80
characters.
Release Modification
4.0(1) This command was introduced.