Cisco Nexus 7000 Series

C Commands
cfs eth
42
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
cfs eth
To globally configure the device to use Ethernet to distribute changes for all Cisco Fabric Services
(CFS)-enabled applications, use the cfs eth command. To remove the CFS configuration, use the no form
of this command.
cfs eth {distribute}
no cfs eth distribute
Syntax Description
Defaults None
Command Modes Global configuration mode (config)
Supported User Roles network-admin
vdc-admin
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to configure the device to use Ethernet to distribute changes for all
CFS-enabled applications:
switch(config)# cfs eth distribute
switch(config)#
This example shows how to remove the CFS configuration:
switch(config)# no cfs eth distribute
This will prevent CFS from distributing over Ethernet network.
Are you sure? (y/n) n
switch(config)#
Related Commands
distribute Enables CFS distribution over Ethernet.
Release Modification
4.1(2) This command was introduced.
Command Description
cfs distribute Globally enables CFS distribution for the device.
show cfs status Displays the CFS distribution status.