Cisco Nexus 7000 Series

Show Commands
show diagnostic events
456
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
show diagnostic events
To display information about diagnostic events, use the show diagnostic events command.
show diagnostic events [error | info]
Syntax Description
Defaults None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to display diagnostic events:
switch# show diagnostic events
1) Event:E_DEBUG, length:114, at 404616 usecs after Wed Jan 7 09:38:46 2009
[104] Event_INFO: TestName->ASICRegisterCheck TestingType->helth monitoring module->
9 Result->pass Reason->Success
2) Event:E_DEBUG, length:114, at 414835 usecs after Wed Jan 7 09:38:26 2009
[104] Event_INFO: TestName->ASICRegisterCheck TestingType->helth monitoring module->
9 Result->pass Reason->Success
3) Event:E_DEBUG, length:107, at 294482 usecs after Wed Jan 7 09:38:23 2009
[104] Event_INFO: TestName->PwrMgmtBus TestingType->helth monitoring module->9 Resul
t->pass Reason->Success
This example shows how to display diagnostic events by information type:
switch# show diagnostic events info
1) Event:E_DEBUG, length:114, at 934712 usecs after Wed Jan 7 11:40:06 2009
error (Optional) Displays diagnostics by error type.
info (Optional) Displays diagnostics by information type.
Release Modification
4.1(2) This command was introduced.