Cisco Nexus 7000 Series

S Commands
source
399
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
source
To configure the NetFlow exporter interface to use to reach the NetFlow collector for the configured
destination, use the source command. To remove the source, use the no form of this command.
source if-type if-number
no source [if-type if-number]
Syntax Description
Defaults None
Command Modes NetFlow exporter configuration (config-flow-exporter)
Supported User Roles network-admin
vdc-admin
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to configure the NetFlow exporter source interface:
switch(config)# flow exporter Netflow-Exporter-1
switch(config-flow-exporter)# source Ethernet3/11
switch(config-flow-exporter)#
This example shows how to remove the Netflow exporter source interface configuration:
switch(config-flow-exporter)# no source Ethernet3/11
switch(config-flow-exporter)#
Related Commands
if-type Interface type. For more information, use the question mark (?) online help function.
if-number Interface or subinterface number. For more information about the numbering syntax
for your networking device, use the question mark (?) online help function.
Release Modification
4.0(1) This command was introduced.
Command Description
show flow exporter Displays information about NetFlow exporters.