Cisco Nexus 7000 Series

Show Commands
show hardware flow sampler
508
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
show hardware flow sampler
To display information about sampled NetFlow hardware flows, use the show hardware flow sampler
command.
show hardware flow sampler {all | count | index number | name sampler-name | vdc vdc_id}
[detail] [module module] [instance instance]
Syntax Description
Defaults None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines You must have already enabled traffic monitoring with Flexible NetFlow before you can use the
show
hardware flow sampler command.
This command does not require a license.
Examples This example shows how to display the NetFlow sampler table utilization for module 2:
switch# show hardware flow sampler count module 2
Sampler Table Utilization: about 0.00% (0/64)
all Specifies all sampled NetFlow hardware flows.
count Specifies the sampler table utilization.
index number Specifies the sampler table index, in hexidecimal. The range is from 0x0 to
0x3ff.
name sampler-name Specifies the sampler name. The name can be any case-sensitive,
alphanumeric string up to 64 characters.
vdc vdc-name Specifies the virtual device context (VDC) name. The VDC name can be any
case-sensitive, alphanumeric string up to 64 characters.
detail (Optional) Displays detailed information about the flows.
module slot-number (Optional) Displays information that is specific to a module.
instance instance (Optional) Displays the instance number.
Release Modification
4.0(1) This command was introduced.