Cisco Nexus 7000 Series

Show Commands
show module
555
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
show module
To display module information, use the show module command.
show module [slot {bandwidth-fairness | recovery-steps} | uptime | xbar [xbar-slot]]
Syntax Description
Defaults Displays module information for all I/O modules and supervisor modules in the chassis.
Command Modes Any command mode
Supported User Roles network-admin
vdc-admin
network-operator
vdc-operator
Command History
Usage Guidelines This command does not require a license.
slot (Optional) Number of the slot for an I/O module or a supervisor module.
bandwidth-fairness Displays the status of the bandwidth fairness for the module.
recovery-steps Displays the steps to recover the module from a down state.
uptime (Optional) Displays the amount of time since the modules were reloaded.
xbar (Optional) Displays information about a fabric module.
xbar-slot (Optional) Number of the slot for the fabric module.
Release Modification
4.0(1) This command was introduced.
4.1(2) Output modified to show diagnostic events.