Cisco Nexus 7000 Series

L Commands
lldp transmit
238
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
lldp transmit
To enable the transmission of Link Layer Discovery Protocol (LLDP) packets on an interface, use the
lldp transmit command. To disable the transmission of LLDP packets, use the no form of this command.
lldp transmit
no lldp transmit
Syntax Description This command has no arguments or keywords.
Defaults Enabled
Command Modes Interface configuration mode
Supported User Roles network-admin
vdc-admin
Command History
Usage Guidelines Make sure that you are in the correct virtual device context (VDC). To switch VDCs, use the switchto
vdc command.
Make sure that you have globally enabled the LLDP on the device.
This command does not require a license.
Examples This example shows how to enable the transmission of LLDP packets on an interface:
switch(config)# interface ethernet 7/1
switch(config-if)# lldp transmit
switch(config-if)# exit
switch(config)#
This example shows how to disable the transmission of LLDP packets on an interface:
switch(config)# interface ethernet 7/1
switch(config-if)# no lldp transmit
switch(config-if)# exit
switch(config)#
Release Modification
5.0(1) This command was introduced.