Cisco Nexus 7000 Series

L Commands
logging event
244
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
logging event
To log interface events, use the logging event command.
logging event {link-status | trunk-status} {enable | default}
no logging event {link-status | trunk-status} {enable | default}
Syntax Description
Defaults None
Command Modes Global configuration mode
Supported User Roles network-admin
vdc-admin
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to log interface events:
switch# configure terminal
switch(config)# logging event link-status default
switch(config)#
Related Commands
link-status Logs all UP/DOWN and CHANGE messages.
trunk-status Logs all TRUNK status messages.
default Specifies that the default logging configuration is used by interfaces not explicitly
configured.
enable Specifies to enable logging to override the port level configuration.
Release Modification
4.0(1) This command was introduced.
Command Description
show logging Displays the logging status.