Cisco Nexus 7000 Series

N Commands
ntp disable
296
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
ntp disable
To disable Network Time Protocol (NTP), use the ntp disable command. To reenable NTP, use the no
form of this command.
ntp disable {ip | ipv6}
no ntp disable {ip | ipv6}
Syntax Description
Defaults Enabled
Command Modes Interface configuration mode
Supported User Roles network-admin
vdc-admin
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to disable NTP:
switch# ntp disable
Related Commands
ip Disables IPv4 on the interface.
ipv6 Disables IPv6 on the interface.
Release Modification
6.2(2) This command was introduced.
Command Description
ntp enable Enables NTP.