Cisco Nexus 7000 Series

L Commands
lldp tlv-select
236
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
lldp tlv-select
To configure the type, length, and value (TLV) descriptions to send and receive in Link Layer Discovery
Protocol (LLDP) packets, use the lldp tlv-select command. To remove the TLV configuration, use the
no form of this command.
lldp tlv-select [dcbxp | management-address | port-description | port-vlan | system-capabilities
| system-description | system-name]
no lldp tlv-select [dcbxp | management-address | port-description | port-vlan |
system-capabilities | system-description | system-name]
Syntax Description
Defaults By default, all available TLVs are enabled.
Command Modes Global configuration mode (config)
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines Make sure that you are in the correct virtual device context (VDC). To switch VDCs, use the switchto
vdc command.
This command does not require a license.
dcbxp (Optional) Specifies the DCBXP TLV.
management-address (Optional) Specifies the Management Address TLV.
port-description (Optional) Specifies the Port Description TLV.
port-vlan (Optional) Specifies the Port VLAN ID TLV.
system-capabilities (Optional) Specifies the System Capabilities TLV.
system-description (Optional) Specifies the System Description TLV.
system-name (Optional) Specifies the System Name TLV.
Release Modification
5.0(1) This command was introduced.