Cisco Nexus 7000 Series

Show Commands
show lldp neighbors
523
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
show lldp neighbors
To display the status of the Link Layer Discovery Protocol (LLDP) neighbor device, use the show lldp
neighbors command.
show lldp neighbors {detail | interface ethernet slot/port-number}
Syntax Description
Defaults None
Command Modes Any command mode
Supported User Roles network-admin
vdc-admin
network-operator
vdc-operator
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to display the LLDP neighbor device status:
switch(config)# show lldp neighbors detail
Capability codes:
(R) Router, (B) Bridge, (T) Telephone, (C) DOCSIS Cable Device
(W) WLAN Access Point, (P) Repeater, (S) Station, (O) Other
Local Intf Chassis ID Port ID Hold-time Capability
Eth8/24 0018.bad8.5e45 Eth8/23 120 R
Eth8/23 0018.bad8.5e45 Eth8/24 120 R
switch(config)#
detail Displays LLDP neighbor detail information.
interface
ethernet
Specifies the interface for which you are displaying LLDP infromation.
slot/port-number Slot number and port number in this format: slot/port-number. The range is from 1
to 253.
Release Modification
5.0(1) This command was introduced.