Cisco Nexus 7000 Series

I Commands
ip dscp
219
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
ip dscp
To configure the differentiated devices code point (DSCP) value of the packets in the Encapsulated
Remote Switched Port Analyzer (ERSPAN) traffic, use the ip dscp command.
ip dscp dscp_value
Syntax Description
Defaults 0
Command Modes config-erspan-src
Supported User Roles network-admin
network-operator
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to configure the DSCP value of the packets in the ESRSPAN traffic:
switch# configure terminal
switch(config)# monitor session 5 type erspan-source
switch(config-erspan-src)# ip dscp 10
switch(config-erspan-src)#
Related Commands
dscp_value Value of the DSCP of the packets in the ERSPAN traffic. The range is from 0 to
63.
Release Modification
5.1(1) This command was introduced.
Command Description
ip ttl Configures the IP time-to-live (TTL) value of the ERSPAN traffic.
monitor-session Enters the monitor configuration mode for configuring an ERSPAN or
SPAN session for analyzing traffic between ports.