Cisco Nexus 7000 Series

L Commands
logging module
253
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
logging module
To enable module log messages, use the logging module command. To disable module log messages,
use the no form of this command.
logging module [severity-level]
no logging module
Syntax Description
Defaults None
Command Modes Global configuration mode
Supported User Roles network-admin
vdc-admin
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to enable module log messages:
switch# configure terminal
switch(config)# logging module
switch(config)#
severity-level (Optional) Number of the desired severity level at which messages should be
logged. Messages at or numerically lower than the specified level are logged.
Severity levels are as follows:
• 0—emergency: System unusable
• 1—alert: Immediate action needed
• 2—critical: Critical condition
• 3—error: Error condition
• 4—warning: Warning condition
• 5—notification: Normal but significant condition—default level
• 6—informational: Informational message only
• 7—debugging: Appears during debugging only
Release Modification
4.0(1) This command was introduced.