Cisco Nexus 7000 Series

F Commands
feature ptp
179
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
feature ptp
To enable the Precision Time Protocol (PTP) feature on the current virtual device context (VDC), use
the feature ptp command. To disable the PTP feature, use the no form of this command.
feature ptp
no feature ptp
Syntax Description This command has no arguments or keywords.
Defaults Disabled
Command Modes Global configuration mode
Supported User Roles network-admin
vdc-admin
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to enable the PTP feature on the current VDC:
switch# configure terminal
switch(config)# feature ptp
switch(config)#
This example shows how to disable the PTP feature on the current VDC:
switch(config)# no feature ptp
2011 Jul 5 06:11:07 switch %FEATURE-MGR-2-FM_AUTOCKPT_IN_PROGRESS: AutoCheckpoi
nt system-fm-ptp's creation in progress...
2011 Jul 5 06:11:07 switch %FEATURE-MGR-2-FM_AUTOCKPT_SUCCEEDED: AutoCheckpoint
created successfully
switch(config)#
Related Commands
Release Modification
5.2(1) This command was introduced.
Command Description
ptp source Configures the source IP address for all PTP packets.
ptp domain Configures the domain number to use for this clock.
ptp priority1 Configures the priority1 value to use when advertising this clock.