Cisco Nexus 7000 Series

Show Commands
show lldp interface ethernet
522
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
show lldp interface ethernet
To display the Link Layer Discovery Protocol (LLDP) configuration on the interface, use the show lldp
interface ethernet command.
show lldp interface ethernet slot/port-number
Syntax Description
Defaults None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to display the LLDP configuration on the interface:
switch(config)# show lldp interface ethernet 6/3
Interface Information:
Enable (tx/rx/dcbx): Y/Y/Y Port Mac address: 00:24:f7:19:84:72
switch(config)#
Related Commands
slot/port-number Slot number and port number in this format: slot/port-number. The range is from 1
to 253.
Release Modification
5.0(1) This command was introduced.
Command Description
show lldp traffic
interface ethernet
Displays the number of LLDP packets sent and received on the interface.
show running-config
lldp
Displays the global LLDP configuration.
lldp transmit Enables the transmission of LLDP packets on an interface.
lldp receive Enables the reception of LLDP packets on an interface.