Cisco Nexus 7000 Series

S Commands
system test-preupgrade running-ver
419
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
system test-preupgrade running-ver
To test the running software version before an upgrade, use the system test-preupgrade running-ver
command.
system test-preupgrade running-ver version-number target-ver target-number swid id impact
impact-number
Syntax Description
Defaults None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to test the running software version before an upgrade:
switch(config)# system test-preupgrade running-ver 4.2<0.202> target-ver Update
swid 4.2.1 impact 0
System will be upgraded according to following table:
Module Swid Impact Running-Version New-Version Upg-Required
------ ---------- ---------- -------------------- -------------------- ------------
6 4.2.1 hitless 4.2<0.202> Update
1
9 4.2.1 hitless 4.2<0.202> Update
1
11 4.2.1 hitless 4.2<0.202> Update
version-number Software version number currently running on the system.
target-ver Specifies the target version of the software.
target-number Target version.
swid Specifies the software ID of the image running on a module: system or kickstart.
id Software ID.
impact Specifies the impact: 0 for hitless and 1 for hitful.
impact-number Impact number.
Release Modification
4.0(1) This command was introduced.