Cisco Nexus 7000 Series

R Commands
record netflow
349
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
record netflow
To select a traditional Layer 2 record for the NetFlow monitor, use the record netflow command. To
remove the record selection, use the no form of this command.
record netflow layer2-switched input
no record netflow layer2-switched input
Syntax Description
Defaults None
Command Modes NetFlow monitor configuration
Supported User Roles network-admin
vdc-admin
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to select a traditional Layer 2 record for the NetFlow monitor:
switch(config)# flow monitor FLowMonitor1
switch(config-flow-monitor)# record netflow layer2-switched input
switch(config-flow-monitor)#
This example shows how to remove the traditional Layer 2 NetFlow record selection:
switch(config-flow-monitor)# no record netflow layer2-switched input
switch(config-flow-monitor)#
Related Commands
layer2-switched Specifies the traditional Layer 2 NetFlow collection scheme.
input Specifies the input NetFlow.
Release Modification
4.0 This command was introduced.
Command Description
record Specifies a flow record to be used by a NetFlow monitor.
record netflow-original Selects an input IPv4 record.