Cisco Nexus 7000 Series

Show Commands
show diagnostic status
462
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
show diagnostic status
To display the test status for all tests, use the show diagnostic status command.
show diagnostic status module slot
Syntax Description
Defaults None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to display information about the test status for all tests on a module:
switch# show diagnostic status module 6
<BU>-Bootup Diagnostics, <HM>-Health Monitoring Diagnostics
<OD>-OnDemand Diagnostics, <SCH>-Scheduled Diagnostics
==============================================
Card:(6) Supervisor module-1X
==============================================
Current running test Run by
-NA- -NA-
Currently Enqueued Test Run by
-NA- -NA-
switch#
slot Diagnostic status slot number. The range is from 1 to 10.
Release Modification
4.0(1) This command was introduced.