Cisco Nexus 7000 Series

Show Commands
show hardware flow utilization
510
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
show hardware flow utilization
To display information about NetFlow hardware flow utilization, use the show hardware flow
utilization command.
show hardware flow utilization [module module]
Syntax Description
Defaults None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines You must have already enabled traffic monitoring with Flexible NetFlow before you can use the
show
hardware flow utilization command.
This command does not require a license.
Examples This example shows how to display the NetFlow sampler table utilization for module 2:
switch# show hardware flow utilization module 2
Flow Utilization: 0.00% (0/515090)
Total number of flows = 0
IPv4 flow creation failure = 0
IPv6 flow creation failure = 0
MPLS flow creation failure = 0
L2 flow creation failure = 0
IFE flow creation failure = 0
OFE flow creation failure = 0
IFE CF FIFO full failure = 0
OFE CF FIFO full failure = 0
IFE NT table full failure = 0
OFE NT table full failure = 0
NO freelist pointer failure = 0
Hash Table(NH) page full failure = 0
IPMAC lookup failure = 0
L2 ACL deny = 0
module slot-number (Optional) Displays information specific to a module.
Release Modification
4.0(1) This command was introduced.