F Commands
filter frame-type eth
190
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
filter frame-type eth
To configure the Ethernet frame type filter for the Ethernet Switched Port Analyzer (SPAN) or
Encapsulated Remote Switched Port Analyzer (ERSPAN) session, use the filter frame-type eth
command. To remove the Ethernet frame type filter, use the no form of this command.
filter frame-type eth
no filter frame-type eth
Syntax Description This command has no arguments or keywords.
Command Modes config-monitor mode (for a SPAN session)
config-erspan-src mode (for an ERSPAN session)
Supported User Roles network-admin
vdc-admin
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to configure the Ethernet frame type filter for a SPAN session:
switch(config)# monitor session 1
switch(config-monitor)# filter frame-type eth
This example shows how to configure the Ethernet frame type filter for an ERSPAN session:
switch(config)# monitor session 1 type erspan-source
switch(config-erspan-src)# filter frame-type eth
Related Commands
Release Modification
6.2(2) This command was introduced.
Command Description
filter (ERSPAN) Configures the filters for an ERSPAN session.
filter (SPAN) Configures the filters for a SPAN session.
filter frame-type arp Configures the ARP frame type filter for the ERSPAN session.
filter frame-type fcoe Configures the FCoE frame type filter for the SPAN or ERSPAN session.
filter frame-type ipv4 Configures the IPv4 frame type filter for the SPAN or ERSPAN session.
To Next Page
Loading...
