N Commands
ntp access-group
286
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
The ntp access-group match-all command causes the access group options to be scanned in the
following order, from least restrictive to most restrictive: peer, serve, serve-only, query-only. If the
incoming packet does not match the peer access group, the packet goes to the serve access group to be
processed. If the packet does not match the serve access group, it goes to the next access group and so
on. This command also enables IPv6 access group processing.
The ntp access-group match-all command is available beginning with Cisco NX-OS Release 6.2(2). If
you enter the no form of this command, do not enter this command or create an access group using an
earlier version of Cisco NX-OS. ACL processing stops and does not continue to the next access group
option if the incoming packet does not match the peer access group or if NTP matches a deny ACL rule
in a configured peer.
This command does not require a license.
Examples This example shows how to configure a peer access group for NTP:
switch# config t
switch(config)# ntp access-group peer Admin_Group_123
switch(config)#
This example shows how to remove an NTP peer access group:
switch# config t
switch(config)# no ntp access-group peer Admin_Group_123
switch(config)#
Related Commands Command Description
feature ntp Enables the NTP on a VDC.
show ntp
access-groups
Displays the NTP access groups.
To Next Page
Loading...
