Cisco Nexus 7000 Series - Page 354

P Commands
power efficient-ethernet
326
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
power efficient-ethernet
To enable Energy Efficient Ethernet (EEE) for the port or port range, use the power efficient-ethernet
command. To disable this feature, use the no form of this command.
power efficient-ethernet auto | sleep threshold aggressive
no power efficient-ethernet auto | sleep threshold aggressive
Syntax Description
Defaults no power efficient-ethernet (that is EEE is off).
Command Modes Global configuration mode
Supported User Roles network-admin
vdc-admin
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to enable auto negotiation for EEE for the port or port range:
switch(config-if)# power efficient-ethernet auto
ERROR: Ethernet2/1: Port is not capable of Energy Efficient Ethernet
This example shows how to enable EEE LPI threshold aggressive sleep mode:
switch(config-if)# power efficient-ethernet sleep threshold aggressive
ERROR: Ethernet2/1: Port is not capable of Energy Efficient Ethernet
Related Commands
auto Specifies auto negotiation for EEE.
sleep Specifies the EEE low power idle sleep configuration.
threshold Specifies the EEE low power idle sleep threshold.
aggressive Specifies the EEE low power idle aggressive sleep mode.
Release Modification
6.1(2) This command was introduced.
Command Description
show module Displays information about a module.