P Commands
ptp announce
331
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
This example shows how to remove the interval configuration for PTP messages:
switch(config)# interface ethernet 5/1
switch(config-if)# no ptp announce interval 1
switch(config-if)#
Related Commands Command Description
ptp Enables or disables PTP on an interface.
ptp delay-request
minimum interval
Configures the minimum interval allowed between PTP delay-request
messages when the port is in the master state.
ptp sync interval Configures the interval between PTP synchronization messages on an
interface.
ptp vlan vlan Configures the PTP VLAN value on an interface.
To Next Page
Loading...
